toggle

  Home > Firearm Parts > AR-10 > Lower Receiver Parts >

KNS .Gen 2 Non-Rotating Trigger/Hammer Pins .155 Diameter - Black
KNS .Gen 2 Non-Rotating Trigger/Hammer Pins .155 Diameter - Black


 
Our Price: $30.95

Quantity in Stock:1
Product Code: KNS-NRTHP155
Qty:

Description
 
  • These are the Generation 2 Non-Rotating Trigger/Hammer Pins.
  • They are the STRONGEST pins that can be produced and were designed to withstand the high impact of full and semi-automatic 9mm and .223 suppressed weapons.
  • They will also fit the .308 AR rifles.
  • The pins are stainless steel.
  • End retainers are black Nitride.
  • An absolute must-have for all M-16 owners.
  • They will also protect your AR-15.
  • Special anti-creep retainers prevent wear on your irreplaceable M-16 or AR-15 receiver.
  • Pin installation tool & 2 TORX wrenches & screws included.
  • No modification to firearm required.

THE TORQUE SPEC ON THE SCREW IS 11 inch/lbs. MAXIMUM. We recommend 8INCH/LBS of torque.

IMPORTANT NOTE: The external width of some AR receivers may vary in the trigger/hammer pin area depending on the manufacturer. The pins being too long will not affect the function or performance. The only difference from the Gen 2 pin kit is the appearance of the sideplates. There is no strength difference.

PLEASE READ the INSTRUCTIONS!!! Over-torquing the screws can cause damage to these sideplates. Engagement length for trigger/hammer pins is .900"

Share your knowledge of this product. Be the first to write a review »